AskPatty Certified Female Friendly Logo

Automotive Advice

At AskPatty, we focus on giving the best automotive advice for helping people with their car questions. If you have a car question, start by asking our automotive experts. You can also use the search bar in the top right to search for a specific issue. All car questions are welcome and we look forward to helping you!


Ask a QuestionSearch for Cylinder Head Questions - Page 1 of 1


2 weeks after I had my Audi A4 engine completely remanned, by Audi, a coolant hose burst while driving on freeway, causing the engine to overheat. Now they say I need a whole new cylinder head and they won
What would a used vehicle with 70,000 mile possibly need? I was told to ask if the timing belt had been changed before buying the car because this is very costly? Should I repair the car's cylinder head? cost $2000. The car has 250,000 miles and my daughter 20 year old loves driving this car. I have spent 2500 for a new tires,thermostat,fan clutch,wheel ...
2005 ford f350 automatic 5.4 liter. code p0022 intake camshaft position timing - over retarded (bank 2) . does this mean I just need to advance the timing? When truck gets hot there is a clattering noise. I have been told by a service advisor that it needs to be inspected for damage to the cam bearings and if so i will need new cylinder head(s). Please ...
Lexus IS 300 2001. My vehicle overheated and warped the cylinder head without blowing the gasket. The head was replaced and everything reassembled, but now there is a slight knocking noise and a rough idle what could cause this? Do you think the timing is off?
Hi, I need advice and intelligent options. I have a 1993 Mitsubishi 3000 GT (V6 3.0L 2972cc 181CID FI GAS N B). Since I first got her back in 2003, she has only broken down twice. The first time was in May of 2007. It was the transmission and that was five years ago. I had the entire tranny rebuilt at a place called Daffy Daves in Key West. While she was ...
My Honda Accord 2003 has over 150,000 miles on it. I recently had to replace some parts such as the battery, timing belts, water pump, drive belt, etc. that I consider "maintenance" parts. However, it was also necessary to replace the cylinder head and head gasket set. Could this also be attributed to "wear and tear" ?

Komatsu SAA12V140E-3 engine installed on Komatsu PC2000 excavator. An issue description: After about 30 000 working hours the engine installed on a mining excavator Komatsu PC2000 was completely overhauled with new original parts. After 1470 working hours after the repair engine was stopped due to coolant in the oil and white exhaust smoke on one side. ...


Need Car Advice?

Ask The Experts!

Looking for a New or Used Car?

Search for our Certified Female Friendly® Car Buying Marketplace locations

Help Our Charities