At AskPatty, we focus on giving the best automotive advice for helping people with their car questions. If you have a car question, start by asking our automotive experts. You can also use the search bar in the top right to search for a specific issue. All car questions are welcome and we look forward to helping you!
Ask a QuestionSearch for Wrangler Questions - Page 1 of 2
Hi - i just picked up my New Jeep Wrangler 2007 last night, and this morning I noticed a "chirping" sound. I took the vehicle to the Dealer and they said that the clutch release bearing is defective. When I compress the clutch, the sound does disappear. They said to make this repair they will have to remove the transmission, when they replace the part. ...
new 2005 jeep wrangler that was in karina and the salw water went to the steering wheel is it good
what could be causing my 1997 jeep wrangler 4cyl engine to Sometimes shake/vibrate when i go over a bump. My wheel will shake really bad for a few seconds than stops.
I have a 1997 Jeep Wrangler (just a basic Wrangler; not an SE, Sport nor Sahara). The windshield fluid dispensers on the hood often get clogged/frozen in the winter. Is there a way to prevent this or fix it when it happens? I tried poking a pin into the holes of the two dispensers but that rarely works.
I cannot get my o2 sensor off my 98 jeep wrangler. tried warming the engine, borrowed the wrench from autozone, even tried some liquid wrench (was replacing it so I figured it did not matter) I am not a weakling but I cannot make this thing budge!. The car is not on a lift, I just slide under. is my body angle not right? this is just too silly not to ...
I have 2006 Jeep Wrangler with 4 wheel drive. When i tried to shifted the gear, it is not shifting to drive to go forward. The shift gear is moving too freely. Help!
Just put new cam lifters intake and heads on my 1969 ford mustang motor which is in my jeep wrangler. Its a 351 Windsor can't get the correct time had it running once. What is the easiest way to time it? and how do I adjust the motor craft carb for new settings to run right?