Hi,
I am replacing the Front Wheel Bearing/Hub Assembly on 92 Buick LeSabre.
The three bolts securing the Assembly are difficult to remove.
They look like Torx. I have tried T-50 and T-55. No go. I have tried a 9mm hex. No go.
What do I do?
Any help would be greatly appreciated.
Thanks!
Mike
Answers from the Automotive Experts
Dear Mike,
From the procedure that I can see it is definitely a torx. You'll have to try different sizes until you find the right one. Unfortunately it doesn't tell me the size.
Once you find it you may need to use an impact driver to get it off. If this is the first time removing them...they could be tough. Good luck.
Lori Johnson
www.ladiesstartyourengines.netContribute to this question:
blog comments powered by Disqus
Related Buick LeSabre FAQs
- This may not be in something you deal with but I need some support about a bad car repair ... Read More
- How much is a 2000 buick LaSabre cost book value? Read More
- It jukes alittle check engine light just came on today but it pick up speed on time are ... Read More
- The heater is blowing hot air on passenger side and cold air on drivers side of my Buick ... Read More
- What should i pay for a 2003 Buick LeSabre? Read More
- My 2002 Buick LeSabre has been "herky jerky" as of late. My car will turn on (turn over), ... Read More
- I bought a 2000 Buick LeSabre the turn signals and the speedometer will not work. I can't ... Read More
- How much should a tune up for my 2000 Buick LeSabre cost at 130,000 miles? Read More
- I have a duo temp on the air conditioner. One side blows cold and the other blows hot. ... Read More
- I have a Buick LeSabre with 75000 miles on it. Lately it's begun to stall on me. I know ... Read More
Need Car Advice?
Ask The Experts!Specials Nearby
Fairfax Auto Repair 17.8 miles- Scott's Automotive Specialists, Inc. 19.8 miles
- J & J Automotive Services 21.3 miles
- Shockley Honda 22.9 miles
- DARCARS Toyota of Frederick 23 miles
- Rick's Auto Body 24.4 miles
Help Our Charities
