HOW DO I REPLACE A BRAKE LAMP IN A 2003 CHRYSLER SEBRING?
Answers from the Automotive Experts
I found a great website for Chrysler Sebring Owners.
http://members.aol.com/_ht_a/SilverSebring/ownerse9.htm
you can ask questions regarding your sebring to drawsoncad2@aol.com
Best of Luck,
Amy Mattinat
Chris,
Unfortuantely, to get to a bulb is a different process on just about every make and model. Look around the lens. There may be screws holding it in. You might have to open the trunk to see them. Sometimes you even have to pull the carpet away a little bit inside the trunk and there will be screws or nuts you have to take off. The lens will take a little pulling, but if you find yourself pulling too hard, you probably missed a screw somewhere. As for the bulb itself, usually they just pull right out, but sometimes you have to push on them just a little bit and turn.
Suzanne
Dear Chris,
Are you trying replace the bulb? If so, you need to find the connector for the bulb and see how to get it out. Most of them need to be twisted and then you can remove the light socket. Look in your owner's manual. A lot of them show how to replace bulbs.
If it's the whole brake light assembly, then you'll probably have to consult a service manual. Look in the body section. Sometimes the bumpers have to be removed to take out some the bolts holding them in place. If you have the part, try to match it up and see if you can find the place on the vehicle where it connects. Sometimes it's just a matter of removing nuts and the whole assembly comes off. Good luck.
Lori Johnson