At AskPatty, we focus on giving the best automotive advice for helping people with their car questions. If you have a car question, start by asking our automotive experts. You can also use the search bar in the top right to search for a specific issue. All car questions are welcome and we look forward to helping you!
Ask a QuestionAutomotive Advice - Page 259 of 676
I just purchased a used 05 Nissan Xterra, V6. I'd like to put the best oil filter and oil in the vehicle when I get my oil changed. I'm confused about what brand filter and which oil to use. What's your advise?
I have a envoy slr. When I reverse there is a squealing coming from the rear. It only happens when the vehicle is cold.
I started smelling a strong chemical odor in my car. Took it to my mechanic and he said that the air conditioning evaporator was leaking and needed to be replaced. They disconnected so that it wouldn't come into the car. Cost estimate to replace is $900 because they have to remove the inside dash. Is that correct? Have been driving without ac but I live in ...
I received a P000B code via a diagnostic test at the local Pepboys. Apparently, this is due to a fault/ and or dirty screens on the camshaft position solenoid valves which was released in the TSB PIP-4644 from Saturn to its service departments. Before turning a wrench, is this correct diagnosis on my part?
Hi I have a 1999 Dodge Durango and my AC blows out hot air and no air blows out the front vents I went yesterday and brought some antifreeze and that got it a little cooler for about 10 minutes and I went right back hot again what can the issue be?
The rear brake pads on my Subaru Forester only had 2/32" left on them and have to be changed. Fronts are OK. What would make the rear wear so much faster than the front? I thought the opposite was true? Do I have to change rotors whenever I change brake pads if no damage is evident? Thanks
Truck does not like to start when wet( dry it out at distributer and it starts), is not running well once hot, stalls in reverse and slowing down around corners....my altenator died not too long ago. I replaced it along with new cap, rotor, and plug wires which I just did this week. Now I'm not sure what is going on with it. Any thoughts on where to start ...